Pool deck resurfacing in Sarasota and Venice
Plenty of decks here were finished years ago with a sprayed cool deck texture, or painted more than once since. When it starts to chip, stain or peel, resurfacing gives the whole pool area a clean start.
Example photos of finished floors, shown for the look. Not photos of a specific past job.
Can an old cool deck texture be resurfaced?
Usually, if most of it is still stuck tight: loose or hollow patches come off, cracks are repaired, and the new finish goes over a surface that is properly bonded.
Cool deck is the knockdown texture sprayed onto many older pool decks in Sarasota and Venice. After years of sun, chlorine and pressure washing it wears thin, chips at the edges and holds dirt in the low spots. Where it is still bonded, it can be prepped and resurfaced. Where it lifts in sheets, it has to come off first.
Tap it
Tap the deck with the handle of a screwdriver. Patches that sound hollow have let go of the concrete and come off.
Dirty low spots
Dirt and algae settle in the valleys of an old texture. A pressure wash shows how much of the finish is left.
Edges and coping
Chipping usually starts at the coping, the steps and around drains. Look there first.
Why does pool deck paint keep peeling?
Because paint is a thin film sitting on top of the concrete; water, chlorine and sun get under it, and every new coat adds another layer that can let go.
Store-bought pool deck paint is the quick fix, and for a season it looks fine. Then it lifts where people walk, around the skimmer and wherever water stands. Rolling fresh paint over peeling paint only adds another layer to lift. Old paint usually has to come off, so the new finish bonds to the concrete itself.
Store-bought paint
Thin, easy to roll on, and usually due again after a few seasons.
A resurfacing system
Built up in layers on prepared concrete, with texture for bare feet.
Painted twice already
The more layers there are, the more has to come off first.
What changes when the deck sits under a screen cage?
Shade and damp: the parts of a caged deck that never fully dry grow mildew and algae, and those spots need extra cleaning before a new finish goes on.
Most pools here sit inside a screen enclosure. The cage keeps leaves and bugs out, but the corners by the house and under the roof line stay damp and turn green or black. The cage footings and the screen door threshold need careful work around them, and the screen panels should be protected from dust while the deck is prepped.
Green corners
Mildew and algae are cleaned off and treated so the new finish has a clean surface to grip.
Cage footings
The finish is brought neatly up to the footings and the threshold.
Screens
Ask how the screens and the pool water are protected during prep.
How much grip does a resurfaced pool deck have?
That depends on the texture you choose; for wet, barefoot areas pick a textured finish, and ask which ones suit a pool surround.
A smooth, glossy coating that looks great in a garage is the wrong choice around a pool. Pool deck finishes are textured so wet feet can grip, and the texture can be finer or coarser. Finer is easier to sweep and gentler on bare feet; coarser grips better on slopes and steps.
Steps and ledges
These see the most wet traffic. Ask about more texture there.
Standing water
Point out any spots where water sits after rain, so they can be looked at during prep.
When is the best time to resurface a pool deck in Sarasota?
The drier months, roughly late fall through spring, are the easiest for outdoor coating work; summer afternoon storms make scheduling harder.
Outdoor coatings need dry concrete and a dry forecast while they cure, and that is easier to find between November and May than in the rainy season. If family or winter guests are coming, ask early, because the pool area is out of use while the deck is prepped and finished.
Rainy season
June through September brings frequent afternoon storms. Outdoor work is planned around them.
Pool out of use
Expect the pool area to be closed for the length of the job. Ask for the schedule.
What does pool deck resurfacing cost in Sarasota?
Price depends on the deck, so ask about yours; the area, what is on it now and how much repair it needs move the price most.
Deck size
The square footage of the deck, plus steps, ledges and any walkway to the gate.
What is on it now
Bare concrete, cool deck texture, paint or pavers each need different prep.
Repairs
Cracks, hollow patches, chipped edges and stained areas add work.
Finish and texture
The look you choose and how much texture the surface gets.
How does a pool deck get resurfaced?
Ask
Tell us the deck size, what is on it now and any trouble spots, and ask for a quote.
Clean and prep
The deck is pressure washed, loose material comes off, and the surface is ground and repaired so the new finish has something to grip.
Resurface
The finish goes down in layers, with texture built in for wet feet.
Cure
The deck needs time before bare feet, furniture and pool chemicals go back on it. Ask for the schedule.
Pool deck questions from Sarasota and Venice homeowners
Can a cool deck surface be resurfaced?
Often, if the old texture is still bonded. Loose or hollow areas come off first, and cracks are repaired.
How long will the pool be out of use?
For the prep, the coating and the cure. Ask for the schedule before work starts, and plan around any guests.
Is the new surface slippery when wet?
Pool deck finishes are textured for wet, bare feet. Ask which texture suits your deck, steps and ledges.
Do I need to drain the pool?
Usually not, but ask how the water and the screens are protected while the deck is prepped.
